16
16
AFTER SALES SUPPORT
1300 889 028 (toll free)
MODEL No.:
CSC165XA.9 • 2323 • 05/2019
e-mail:
info.aldi@positecgroup.com
handle and make sure it moves freely and does not touch the
blade or any other part, in all angles and depths of cut.
b) Check the operation of the lower guard spring. If the
guard and the spring are not operating properly, they
must be serviced before use. Lower guard may operate
sluggishly due to damaged parts, gummy deposits, or a build-up
of debris.
c) Lower guard may be retracted manually only for special
cuts such as “plunge cuts” and “compound cuts.” Raise
lower guard by retracting handle and as soon as blade enters
the material, the lower guard must be released. For all other
sawing, the lower guard should operate automatically.
d) Always observe that the lower guard is covering the
blade before placing saw down on bench or floor.
An unprotected, coasting blade will cause the saw to walk
backwards, cutting whatever is in its path. Be aware of the time
it takes for the blade to stop after switch is released.
ADDITIONAL SAFETY RULES FOR YOUR CIRCULAR SAW
1. Only use saw blades recommended in the specification.
2. Do not use any abrasive wheels.
3. Use only blade diameter(s) in accordance with the markings.
4. Identify the correct saw blade to be used for the material to be cut.
5. Use only saw blades that are marked with a speed equal or
higher than the speed marked on the tool.
6. Important information – Product care
NOTE: For any issues related directly to your 20V Li-Ion 165mm
Circular Saw, contact the Customer Service of the manufacturer
as listed on the packaging, manual or on the label on the cordless
circular saw.
This 20V Li-Ion 165mm Circular Saw uses Lithium Ion Battery Cells.
Care MUST be taken to ensure both the safety and life of the pack
is maintained. Ensure you have read all of the safety notes in the
To Next Page
Loading...
Need help?
General
