12
12
AFTER SALES SUPPORT
1300 889 028 (toll free)
e-mail:
MODEL No.:
info.aldi@positecgroup.com
JLH122200370S&Z10&ABP1815MA • 2323 • 05/2019
Battery and Battery Charger.
b) If the battery is very hot, remove the battery from the charger
adaptor and allow time for the battery to cool down before
recharging.
c) The battery in your new tool is not charged when it leaves the
manufacturer. Therefore it must be fully charged before using
for the first time.
d) Charge the battery to reach full or no less than half charge
before storage. If the tool will not be used for long periods of
time, charge the battery every 3-6 months.
7.2 How to charge your battery pack (see fig a)
Charging procedure
1. Connect the battery charger adaptor (1) into the plug pack
charger (2).
2. Connect the plug pack charger (2) in to the 240V mains power
outlet and turn on. A “green” light indicates power.
3. Slide the battery charger adaptor (1) onto the battery (4) by
aligning the guiding rails. A click indicates the battery is fitted.
4. The plug pack charger (2) light will change to “red”. The battery
is now in the charging process. When the light returns to
“green”, the battery (4) is fully charged.
NOTE: The power to the charger should be turned off when
unattended, with or without a battery inserted.
Ambient temperature ranges
The ambient temperature range for tool,
battery use and storage is 0
o
C-45
o
C.
The recommended ambient temperature
range for the charging system during
charging is 0
o
C-40
o
C.
To Next Page
Loading...
Need help?
General
