18
18
AFTER SALES SUPPORT
1300 889 028 (toll free)
MODEL No.:
CID180XA.9 • 2323 • 05/2019
e-mail:
info.aldi@positecgroup.com
G
8.5 Belt Clip (4) (See Fig. G)
The side belt clip (4) is used to assist to clip the Impact Driver to
your waist belt while working. To install, insert the assembly screw
through the belt clip screw hole into the retaining hole on the
Impact Driver, and using a philips head screwdriver (not supplied),
tighten the screw by turning in a clockwise direction
NOTE: The belt clip (4) can be assembled onto either side of the
Impact Driver.
IMPORTANT: When attaching or replacing the belt clip (4), use only
the assembly screw that is provided. Be sure to securely tighten
screw.
8.6 Overload Protection
When in overload condition, the motor will come to a stop. Reduce
the load on the machine immediately and allow to cool for approx.
30 seconds at the highest no-load speed.
8.7 Temperature Cut Out
If the Impact Driver is constantly overloaded, or the Impact Driver is
used constantly at maximum rating in high ambient conditions, the
battery cells may overheat causing the battery pack to shut down.
When this occurs you will need to allow the battery cells to cool.
NOTE: The Impact Driver will not restart until the battery pack has
cooled.
To reduce the temperature of the cells remove the battery pack
from the Impact Driver and place the battery pack in a free air
To Next Page
Loading...
Need help?
General
