20
20
AFTER SALES SUPPORT
1300 889 028 (toll free)
MODEL No.:
CSC165XA.9 • 2323 • 05/2019
e-mail:
info.aldi@positecgroup.com
8.3 Base plate angle adjustment (See Fig. D1, D2)
WARNING: Always ensure that the saw is switched off and the
battery pack (16) is removed before making any adjustments.
Turn the base plate bevel bevel lock knob (6) in an anti-clockwise
direction to loosen the angle scale. Tilt the base plate (11) away
from the machine until the required cutting angle is adjusted on the
base plate angle scale (5). Tighten the base plate bevel lock knob (6)
by turning it in a clockwise direction. Do not use the cutting depth
scale (22) when making bevel cuts due to possible inaccuracy.
C D1 D2
8.4 Dust/chip extraction (See Fig. E)
WARNING: Always ensure that the saw is switched off and the
battery pack (16) is removed before making any adjustments.
To attach the dust extraction adapter (15), place over the dust
extraction port recess area, lining up the screw holes on the adapter
and the holes on the recess. Insert the assembly screws and tighten
in a clockwise direction using a philips head screwdriver (not
supplied). Ensure the fit is secure.
To remove the dust extraction adapter (15), loosen the assembly
screws using a philips head screwdriver (not supplied) in an
anticlockwise direction. Remove the screws, and remove the dust
extraction adapter (15) from the recess.
Directly connect a suitable vacuum hose to the adapter.
NOTE: There is an arrow on the surface of the adapter which shows
which direction to tighten on the hose.
22
23
To Next Page
Loading...
Need help?
General
