Alesis STRIKE - Page 14

14
Parameter Description
V
alues/Settings
EQ EQ lets you “boost” or “cut” low and high frequencies of the
kit’s sound to change its sound.
LF Gain
This determines how much the equalizer’s low-frequency
band is boosted or cut.
-60 to 00 to +12dB
LF Freq
This determines the equalizer’s low frequency.
20 Hz – 18.5 kHz
HF Gain
This determines how much the equalizer’s high-frequency
band is boosted or cut.
-60 to 00 to +12dB
HF Freq
This determines the equalizer’s high frequency.
20 Hz – 18.5 kHz
Comp Comp applies compression to the kit’s sound (decreasing
the dynamic range of the sound to make it more consistent).
Threshold
This determines the volume at which compression will be
applied to the sound. In other words, when the volume of
your playing reaches or exceeds this volume level, it will
trigger the compressor.
-90 to 00dB
Output
This determines the volume of the compressed signal.
20 Hz – 18.5 kHz
F
X
1, FX2 The F
X
processors let you select from different types of
flanger, chorus, vibrato, and delay effects.
Type
This is the type of effect.
See Appendix > Ef
f
ects
Parameters
The available parameters will depend on the type of effect.
See Appendix > Effects