Manual
Timy3 - General
-22-
9.2.3.2 FINISH
This controls the start number continuation for competitors reaching the finish.
• <MANUALLY> no automatic continuation
• <START> only 1 competitor on track from start to finish
• <FINISH> several competitors on track, according to starting order
9.2.3.3 AUTOMATIC-TIME
Set a minimum and maximum runtime. If an impulse is received before the minimum time has
expired, an invalid time is registered. If the maximum time has expired the finish start number
is automatically forwarded to the next started competitor.
• <AUTOTIME-MIN> Standard: 00:00:00 = function disabled
• <AUTOTIME-MAX> Standard: 00:00:00 = function disabled
9.2.4 SEC-MODE
This function sets if runtime is displayed in min/sec or just sec. Not available in all programs
• <NO> Runtime in hh:mm:ss.th
• <YES> Runtime in ssss:th
9.2.5 LANGUAGE
You can adjust the following languages as defaults for the Timy3
• <GERMAN>
• <ENGLISH>
• <FRENCH>
• <ITALIAN>
• <SPANISH>
• <FINNISH>
• <DUTCH>
• <SWEDISH>
9.2.6 STANDARD
Reset the Timy3 to the factory defaults.
• <STANDARD-SETT>
9.2.7 HARDWARE
This menu is only available for our service technicians.
9.2.8 HARDWARE 2
This menu is only available for our service technicians.
9.2.9 PROGS ON OFF
As standard all programs are activated. The programs that are not used can be hidden to re-
duce the select list. Hidden programs can be activated any time in this menu again.
9.2.10 GPS LEP SEC.
The earth rotates a little slower than what was the basis of the second’s definition. As a result,
an actual day lasts a fraction of a second longer than 86400 seconds. This effect adds up.
Therefore, an additional leap second is inserted from time to time. If the Timy3 is always up-
dated with the latest firmware, the leap second is automatically updated with the new firm-
ware. Alternatively, you can enter the leap second manually.
9.2.11 CLR MEMORY
You can clear the memory of the Timy3 in this menu at any time.
To Next Page
Loading...