Manual
Timy3 - General
-27-
9.5.2 RS232
These are settings of the RS232 of the Timy3.
• <MODE> adjustment for output of net time (calculated run time)
and time of day or only time of day
• <BAUDRATE> adjustable is 2400, 4800, 9600 or 19200 Baud
• <SEND MEMORY> sends the memory contents of the Timy3
• <HANDSHAKE> with or without RTS-CTS handshake adjustment
• <TRACK-MODE> norm or ident: change output format of TrackTimer
• <TIMY<->TIMY> communication between two Timy3 (program Stopwatch)
9.5.3 GSM-MODEM
These are settings for a GSM-modem communication. GSM-modems are no longer available!
• <ENTER NR> enter the number to dial
• <SEARCH MODEM > search a connected modem
• <PIN CODE> enter the SIM card pin code
• <STOP GSM-MODEM> disconnect the connection
• <MEMORY SMS send the memory by SMS
9.5.4 GSM-SETTINGS
These are settings for a GSM modem connection. GSM-modems are no longer available!
• <TEL-NR 1> input of the phone number that it dials
• <TEL-NR 2> input of the 2nd phone number that it dials
• <SMS MAX PAK>
• <CONFIG>
9.6 PRINTER
This menu is for setting the printer parameters.
9.6.1 PRINTER-MODE
• <PRINTER OFF> printer is switched off
• <PRINTER ON > printer is switched on (factory setting)
• <PAUSE> printer stops and times will be saved and printed when
printer is switched on again
9.6.2 PRINT STARTTIME
Adjustment if start time is printed immediately after the start.
• < PRI START OFF> prints no start time (factory setting)
• < PRI START ON> prints start time
9.6.3 AUTO LINE FEED
Adjustment of line feeds after printing a data package. It is adjustable between 0 and 9.
• <0> factory setting is zero
9.6.4 START-LOGO
Adjustment whether the ALGE-TIMING logo is printed when switching on the Timy3.
• <OFF> no logo is printed
• <ON> logo is printed (factory setting)
9.6.5 PRINT DAYTIME
Adjustment whether the time of day is printed.
• <OFF> no time of day is printed, only net times (run times)
• <ON> time of day is printed (factory setting)
To Next Page
Loading...