The tool cannot perform the reading
and / or writing
Re-launch the K-Suite software without
pressing SKIP on the main window.
Make sure that the green LED on the left
side of the tool is lit. If it is not lit, please
contact the Technical Support Service to
arrange the return of the tool for repair.
Make sure of using the correct cable and
accessories between K-TAG and vehicle or
ECU.
Make sure that any cables and accessories
are intact and properly connected.
Make sure your soldering are well done
and possibly re-solder them.
Make sure you supplied power to K-TAG
and the ECU.
Make sure you have selected the correct
Family for the ECU connected.
Make sure that the blue LED on the left
side of the tool is lit while attempting to
communicate with the ECU.
If the problem persists, contact the Technical
Support Service providing the error code
displayed and a detailed description of the
operations performed
Error messages: "Checksum error" or
"Correction Checksum Error "
Make sure of using the correct cable and
accessories between K-TAG and vehicle or
ECU.
Make sure that any cables and accessories
are intact and properly connected.
Make sure your soldering are well done
and possibly re-solder them.
Reinstall the K-Suite software, making sure
to confirm the installation of Microsoft
Visual C + + (see section Installing the
software K-Suite - page 14)
If the problem persists, send the file read from
the vehicle and the LOG file to the Technical
Support Service.
Error message: "Micro protection type
not supported. It's impossible to work
on this ECU"
You are trying to communicate with an
ECU equipped with a protected
Microprocessor. If available for the ECU of
interest, use one of the Families dedicated
to this type of ECUs, identifiable by the
initials “TPROT” in the name.
To Next Page
Loading...