Removing the stability foot
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working
inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1. Place the computer on a clean and flat surface with the bottom cover facing up.
2. Pull the securing tab to release the stability foot from the slots on the bottom cover.
3. Lift the stability foot off the bottom cover.
a. bottom cover
b. stability foot
c. security tab
4. Lay the computer on its side.
15
To Next Page
Loading...
