Alienware Aurora R6 - Removing the bottom cover; Prerequisites; Procedure

Removing the bottom cover
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working
inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1. Remove the
left-side cover.
2. Remove the two 2.5-inch hard-drive cages.
Procedure
1. Press the securing tabs to release the bottom cover from the slots on the chassis.
a. securing tabs (8)
b. slots (8)
2. Tilt the computer towards the front until the base is facing up.
3. Lift the bottom cover from the chassis.
27