Alienware Aurora R6 - Removing the rear trim cover; Prerequisites; Procedure

Removing the rear trim cover
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working
inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1. Remove the
left-side cover.
2. Remove the right-side cover.
3. Remove the top cover.
Procedure
1. Place the computer in an upright position.
2. Using the tab, slide and remove the rear trim cover from the chassis.
a. chassis
b. rear trim cover
86