Replacing the Power-Button Board | 31
Replacing the Power-Button
Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the screws holes on the power-button board with the screw holes on the palm-
rest assembly.
2 Replace the screws that secure the power-button board to the palm-rest assembly.
3 Connect the power-button board cable to the system-board connector.
Postrequisites
1 Replace the center control cover. See "Replacing the Center Control Cover" on
page 29.
2 Replace the base cover. See "Replacing the Base Cover" on page 15.
3 Replace the battery pack. See "Replacing the Battery Pack" on page 13.
4 Follow the instructions in "After Working Inside Your Computer" on page 11.
16
Book.book Page 31 Thursday, April 19, 2012 2:38 PM
To Next Page
Loading...
