Rockwell Automation Publication 1734-UM013C-EN-P - August 2010 123
Considerations When Replacing POINT Guard I/O Modules Chapter 8
Scenario 3 - New Module SNN is Different from Original and
No Safety Signature Exists
1. Remove the old I/O module and install the new module.
2. Right-click your POINT Guard I/O module and choose Properties.
3. Click the Safety tab.
4. Click Reset Ownership.
5. Click OK.
6. Follow your company-prescribed procedures to functionally test the
replaced I/O module and system and to authorize the system for use.
To Next Page
Loading...
