Rockwell Automation Publication 5069-UM003A-EN-P - May 2018 63
Configure Compact 5000 I/O Serial Module Chapter 4
Connection Category
The Connection category lets you complete the following tasks:
• Set the RPI rate. For more information on the RPI, see on page 24
.
• Inhibit the module. For more information on inhibit the module, see
page 26
.
• The connection over EtherNet/IP will be Unicast only.
• Configure whether a connection failure while the controller is in Run
module causes a major or minor fault.
TIP The Module Fault area of the Connection category is useful during module
troubleshooting. For more information on the Module Fault area, see
page 71
.
To Next Page
Loading...
