Allen-Bradley E300 - Wire the E300 Relay

Rockwell Automation Publication 193-QR004B-EN-P - January 2017 13
Chapter 1
Wire the E300 Relay
Complete the device wiring according to the appropriate wiring diagrams for your application. You can wire the E300
relay in multiple ways, depending on the accessories, add-on modules, application requirements, etc. The wiring diagrams
in this section are for illustrative purposes only.
For the E300 Electronic Overload Relay to function properly and protect your motor, it needs a control voltage
(24V DC, 120V AC, 240V AC).Connect the control voltage to the device by attaching wires to the A1 (positive) and
A2 (nega
tive) terminals, which are located on the bottom of the control module of the E300 relay. Figure
4 shows this
configuration.
Figure 4 - Control Module Wiring
R24R23
RELAY 2RELAY 1
R14R13
IN3
IN2
Additional Inputs for 193-EIO-63-_ _ _
IN0
IN1
A2
PE
A1A1
A1
R03
R04
A2
IN5
IN4
(+)
(-)
RELAY 0
S2S1
RELAY 1
R14R13
IN3
IN2
IN0
IN1
A2
A1A1
A1
R03
R04
A2
IT2
IT1
(+)
(-)
RELAY 0
193-EIOGP-_ _-_ _ _193-EIO-_ _-_ _ _
PE
Ground
Fault
PTC
Additional Inputs for 193-EIOGP-42-_ _ _
+
t