Rockwell Automation Publication 193-QR004B-EN-P - January 2017 31
Chapter 4
Device Configuration Using the Web Server
In order to make changes to your E300 relay via the Web Server, it needs to be enabled. In Administrative Mode, you can
change any configuration parameter of the E300 relay including permanently enabling the embedded web server. This
chapter explains how to put the E300 relay into Administrative Mode to edit the minimum required parameters
ConfigPreset (Parameter 164) and FLASetting (Parameter 171) using the E300 Web Server.
Before You Begin
Before you can configure the E300 relay via the web server, you must first have completed the configuration explained in
Chapter
1.
What You Need
• E300 relay that has been configured with an IP address and is connected to a network
Follow These Steps
Complete the following steps to configure the E300 relay via the web server. When you have finished, you will have
configured the minimum required parameters for the E300 relay.
Enabling the E300 Relay Web Server
1. Enter Administrative Mode by turning the rotary dials on the E300 relay communication module to 000 and cycle
power on the E300 relay.
2. Using a personal computer, open a web browser and type the IP address of the E300 relay.
3. To permanently enable the E300 Web Server, navigate to Administrative Settings->Network Configuration.
4. When you are prompted for a user name and password, enter "Administrator" for the user name, and enter the
appropri
ate password.
Enable the E300 relay
Web Server
Select the Operating
Mode Using ConfigPreset
(Parameter 164)
Configure FLASetting
(Parameter 171)
To Next Page
Loading...
