22 Rockwell Automation Publication 193-QR004B-EN-P - January 2017
Chapter 2
3. If the upload is successful, a display appears indicating the success of this command. Click OK to continue.
The firmware revision, module types, and existing configuration parameters of the E300 relay are now uploaded into
your project.
Set the Operating Mode
The Operating Mode is an embedded motor control program that is used to reduce motor starter control wiring and
simplify PLC programs. You can choose from 47 different Operating Modes to accommodate the most common motor
control strategies. For more information, see Appendix
A. Follow the steps below to choose the correct Operating Mode
for your motor starter.
1. Double click on the E300 device profile. In the general dis
play, select Change to open the Module Definition
Window.
2. Click on the Motor Control Operating Mode window.
3. Using the dropdown fields, select the appropriate Control Strategy and relay settings that correspond to your
mot
or starter. When you are finished, click OK to close the Module Definition display.
To Next Page
Loading...
