Rockwell Automation Publication 193-QR004B-EN-P - January 2017 27
Chapter 2
Reverse Start Command (Reversing Starter)
Speed 2 Start Command (2-Speed Starter)
The reverse start command for a reversing starter and the speed 2 start command for a two-speed starter will use output
tag:O.LogicDefinedPt01Data to start the motor.
• Overload Start Command
The start command for an E300 overload relay that is in an Overload based Operating Mode use output tag
:O
.Pt00Data, :O.Pt01Data, or :O.Pt02Data to start the motor. This depends on which output relay was wired to
contactor coil.
To Next Page
Loading...
