Sequencer Instructions
Chapter 15
159
the data monitor display of a sequencer instruction and a file instruction
should be noted. The Sequencer Output instruction will be used as an
example. Each column in the sequencer table represents the data for each
output word. This data controls the outputs of the corresponding output
word at each step in the sequencer operation. The status of the outputs can
be observed in the output address data displayed in the header.
In contrast, each column in a File instruction display represents a complete
file. File data is manipulated by the instruction. The result of the
instruction operation is contained in the result file or in a specified word
address of the instruction.
Figure 15.8
Example
Binary Data Monitor Display of a SEQUENCER OUTPUT
BINARY
DA
TA MONITOR
SEQUENCER OUTPUT
COUNTER ADDR: 054
STEP: 008
SEQUENCER LENGTH: 009
FILE: 600621
OUTPUT ADDR:
011 013
DATA: 111
10000 1
1000011 11111
100 0001
1000
MASK ADDR:
211 212
DATA: 1111111
1 1
1111111 1111111
1 1
1000000
STEP
WORD 1 WORD 2
001 001
10101 1
1000101 1111111
1 1
1111111
002 011
10100 0001
1101 0001011
1 001
10011
003 1010111
1 00010101
1110101
1 1
1010100
004 1
1000000 0000001
1
10100001 01010001
005
00010100 000101
11 1010111
1 1
1010101
006 011
10101 1
1101011 1110101
1 1
1101000
007 111011
10 1
1101000 0001111
1 1
1110011
008 111
10000 1
1000011 11111
100 0001
1000
009 0001111
1 1
1110111 1101011
1 10101
111
DAT
A: 1
111111
1 1
1111111
PROGRAM MODE
Field
Cursor
Digit
Cursor
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
