Introduction to Programming
Chapter 4
434
One series condition instruction can be used with a Sequencer Input
and an Examine On or Off Shift Bit in series if the output is a block
instruction.
Up to 4 Examine On or Off Shift Bit instructions can be used in series if
the output is not a block instruction.
Up to 3 Examine On or Off Shift Bit instructions can be used in series if
the output is a block instruction.
Up to 4 branches containing condition instructions can be used in
parallel with an Examine On or Off Shift Bit instruction.
Up to 3 parallel branches containing Examine On or Off Shift Bit
instructions can be programmed in a rung.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
