EasyManuals Logo
Home>Allen-Bradley>Control Unit>SLC 500 BASIC

Allen-Bradley SLC 500 BASIC User Manual

Allen-Bradley SLC 500 BASIC
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #77 background imageLoading...
Page #77 background image
Publication 1746-UM004A-US-P
Lithium Battery Replacement, Handling, and Disposal C-3
Battery Handling
The procedures listed below must be followed to ensure proper battery operation
and reduce personnel hazards:
Use battery only for intended operation.
Do not ship or dispose of cells except according to recommended procedures.
Do not ship on passenger aircraft.
Storage
Store lithium batteries in a cool, dry environment, typically +20
°
C to +25
°
C
(+68
°
F to +77
°
F) with 40% to 60% humidity. Store the batteries and a copy of the
battery instruction sheet in the original container, away from flammable materials.
Transportation
One or Two Batteries - Each battery contains 0.23 grams of lithium. Therefore, up
to two batteries can be shipped together within the United States without
restriction. Regulations governing shipment to or within other countries may
differ.
Three or More Batteries - Procedures for the transportation of three or more
batteries shipped together within the United States are specified by the Department
of Transportation (DOT) in the Code of Federal Regulations, CRF49,
“Transportation”. An exemption to these regulations, DOT – E7052, covers the
transport of certain hazardous materials classified as flammable solids. This
exemption authorizes transport of lithium batteries by motor vehicle, rail freight,
cargo vessel, and cargo-only aircraft, providing certain conditions are met.
Transport by passenger aircraft is not permitted.
ATTENTION
Do not charge the batteries. An explosion could result or the cells
could overheat causing burns.
Do not open, puncture, crush, or otherwise mutilate the
batteries. A possibility of an explosion exists and toxic, corrosive,
and flammable liquids would be exposed.
Do not incinerate or expose the batteries to high temperatures.
Do not attempt to solder batteries. An explosion could result.
Do not short positive and negative terminals together. Excessive
heat can build up and cause severe burns.
Spare Allen-Bradley Parts

Table of Contents

Other manuals for Allen-Bradley SLC 500 BASIC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allen-Bradley SLC 500 BASIC and is the answer not in the manual?

Allen-Bradley SLC 500 BASIC Specifications

General IconGeneral
BrandAllen-Bradley
ModelSLC 500 BASIC
CategoryControl Unit
LanguageEnglish

Related product manuals