Alliance Laundry Systems SWT520*M - No Motor Run - Agitate Analysis

66 39201
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting (EDC Models)
36. No Motor Run — Agitate Analysis
The wash tub has
been filled and
there is no motor
run for agitate.
Replace electronic
control board.
Open
control
panel
Close washer
lid.
NOTE: All checks in this flow chart
are based on the assumption a
high speed agitate and spin cycle
have been selected.
YES
NO
After checking
for correct wiring,
refer to Motor Test
Procedure section
NO
YES
Is the
washer lid
closed?
(1)
Check
voltage at
electronic
control board
BLU "H3-4" to "H3-2"
RED "H3-6" to BRN
"H3-2" is there
voltage?
(#) Numbers next to voltage checks
correspond to the locations marked
on the wiring schematic.
TLW374S
or Motor Does Not
Run paragraph.