Maintenance
Maintenance
NOTE: Read Important Safety Instructions first.
IMPORTANT:
Use the proper chemical agents which
avoid calcium sediments on heating elements and oth-
er machine parts. Discuss the issue with your supplier
of washing products. The manufacturer of the machine
is not responsible for the damage of heating elements
and other machine parts due to calcium sediments.
Daily
IMPORTANT: Do not spray the machine with water.
Short circuiting and serious damage may result.
Beginning of Day
1. Verify that all warning labels are present and legible, replace
as necessary.
2.
Check door interlock before starting operation:
a. Attempt to start the machine with the door open. The ma-
chine should not start.
b. Close the door without locking it and start the machine.
The machine should not start.
c. Attempt to open the door while the cycle is in progress.
The door should not open.
If the door lock and interlock are not functioning properly, dis-
connect power and call a service technician.
3. Check the machine for leaks.
4. Inspect water inlet valve hose connections on the back of the
machine for leaks.
5. Inspect steam hose connections for leaks (if applicable).
6. On machines equipped with an automatic Chemical Supply
System, check all the hoses and hose connections for leaks or
visible signs of deterioration. Replace immediately if either
are present. Chemical leaks can cause damage to the ma-
chine’s components.
7. Verify that insulation is intact on all external wires and that all
connections are secure. If bare wire is evident, call a service
technician.
8. Ensure all panels and guards are properly installed.
End of Day
1. Inspect and clean the basket and door gasket of residual deter-
gent and all foreign matter.
2.
Clean the door glass and between the door gasket and the
door with a damp cloth.
3. Clean supply dispenser lid and general area with mild deter-
gent. Flush the dispenser with clean water.
4. Clean the machine’s top, front and side panels with all-pur-
pose cleaner. Rinse with clean water and dry.
IMPORTANT: Use only isopropyl alcohol to clean
graphic overlays. Never use ammonia-based, vine-
gar- based or acetone-based cleaners on graphic
overlays.
IMPORTANT: Do not use abrasive cleaners.
NOTE: Unload the machine promptly after each
completed cycle to prevent moisture buildup. Leave
loading door open at the end of each completed cy-
cle to allow moisture to evaporate.
5. Leave the loading door open at the end of each day to allow
moisture to evaporate.
6. Shut off water supply.
Cleaning the Filter and Tanks (Machines with Optional
Filter Tanks for Mops)
The filter tank is equipped with an easy to remove filter. Refer to
Figure 42
. This filter catches pollutants during the working cy-
cle. Check and clean the filter daily. Failure to check and clean
the filter can lead to incorrect function of the equipment, which
results in insufficient drainage of waste water into the sewer.
Maintenance
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
72 Part No. D2418ENR6
To Next Page
Loading...
