© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
102
70458301ENR6
Before You Call for Service
Removing Tumble Dryer from Service
If the tumble dryer is to be removed from service,
perform the following steps where applicable:
Turn off electrical supply external to machine.
Turn off electrical disconnect on machine.
Turn off gas supply external to machine.
Turn off manual gas shut-off valve on machine.
Turn off steam supply external to machine.
Remove all electric, gas and steam connections.
Won’t
Start
Won’t
Heat
Clothes
Not Dry
Possible Reason – Corrective Actions
•
Insert correct coin(s) or valid card if applicable.
•
Close the loading door tightly.
•
Close lint panel tightly.
•
Press the PUSH-TO-START or START pad/button.
•
Be sure power cord is plugged all the way into the electrical outlet.
•
Drying timer is in OFF position.
•
Check the main fuse and circuit breaker.
•
Check fuses located in the machine.
•
Insufficient airflow.
•
Gas shut-off valve in OFF position.
•
Are controls properly set?
•
Broken drive belt. Call the service person.
••
Tumble Dryer is in Cool Down Mode.
••
Lint screen clogged. Clean lint screen.
••
Exhaust duct to outside is blocked. Clean out.
To Next Page
Loading...
Need help?
General