© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Operating Instructions
70458301ENR6
88
DMP OPL Models
DO Control Suffix
Description of the OPL Control Panel
Refer to Figure 52.
Figure 52
TMB1956N
1 START. Starts or resumes the current program or cycle.
2 STOP. Temporarily halts the current cycle or cancels the current program.
3 Reversing/Nonreversing (REV). Changes the selection between reversing and nonreversing cylinder action.
4 Reversing LED. Illuminated when set for reversing.
5 Up/Down Arrows. Increases or decreases the value in the display. In conjunction with the DISPLAY button, these
buttons are used to adjust the drying time, cooling time, temperature, clockwise time, dwell time, counter-
clockwise time, and minutes per coin (Coin only).
6 Display. Displays the drying time, cooling time, drying temperature and diagnostic codes.
7 Program Select. This button toggles through the five user programmable programs. Holding this button will save
a program, as indicated in Programming.
8 User Program LEDs. Illumination shows which user program is currently being displayed.
9 Display Select. Toggles the display between the drying time, cooling time, and temperature settings. Pressing
the Display button for 3 seconds allows the user to display the drying cycle temperature.
10 DRYING LED. Illuminated when in the drying cycle.
11 COOLING LED. Illuminated when in the cooling cycle, or when the display is currently showing the time for the
cooling cycle.
12 TEMPERATURE LED. Illuminated when the display is showing the temperature setting.
1
2
3
4
5
DRYING
COOLING
TEMPERATURE
REV START STOP
(CANCEL)
TMB1956N
To Next Page
Loading...
Need help?
General