ALLIED ELECTRONICS NeXGen User Manual

NeXGen  Gilbarco/Bennett - Installation and Start Up Guide
Copyright  2018 by Allied Electronics, Inc.
October 18, 2018 Page
3-5
Product to Position Mapping for Gilbarco Variable Blenders
In the Gilbarco system, the product type to product # assignment can be in any order. For
the 3+0 and 3+1 variable blenders, the following will be used:
POS Product #1: Low grade
POS Product #2: Blended Product
POS Product #3: High grade
POS Product #4: Diesel
Model 3 + 0 Variable blender
The table below lists the proper product to position assignment for each blender type which
is set via the POS fueling point configuration menu.
The blender type setting is not used and should be set to zero (0).
Position Advantage
Product
Adv. w/optimized & Encore
Product
1 Low grade Low grade
2 Not assigned
Blended product
3 Blended product High grade
4 Not assigned Not assigned
5 High grade
Not assigned
6 Not assigned Not assigned
7 Not assigned Not assigned
8 Not assigned Not assigned
* The low grade and the high grade products may be switched depending on the
position of the dispenser and the installation of the product lines.

ALLIED ELECTRONICS NeXGen Specifications

General

Brand	ALLIED ELECTRONICS
Model	NeXGen
Category	Controller
Language	English