Appendix B: Unattended Microsoft Windows Installations
198
6. Step 6. Replace the deleted file “netamd2.in_” from the previous step
with the ATI “netamd2.inf” file that is provided with this document.
7. Save any changes you may have made to the unattend.txt file.
If you need to change the default adapter speed and duplex parameters,
further changes will be needed to be made to the “unattend.txt” file. These
changes are detailed here.
To change default AT-245x/270x Series adapter parameters during
unattended setup
1. You will need to edit the “unattend.txt” file. Add the following entries:
[NetAdapters]
|Adapter01=params.Adapter01
[params.Adapter01]
InfID="pci\ven_1022&dev_2000"
AdditionalParams=params.Adapter01.additional
[params.Adapter01.additional]
; ‘EXTPHY’ is for the AT-245x/270x Series adapters.
Changes the default
; ‘Speed/Duplex’ Setting.
EXTPHY=”1”
2. Edit the EXTPHY= entry to contain the desired speed/duplex value.
See chart below for the possible values.
3. Save your modified “unattend.txt” file.
Table 16. EXTPHY Parameter Values
Value Definition
1 100Mbps/Half Duplex
2 100Mbps/Full Duplex
3 10Mbps/Half Duplex
4 10Mbps/Full Duplex
To Next Page
Loading...
Need help?
General
