Allied Telesis AT-9000/28SP Command Line User's Guide

Chapter 68: ACL Commands
1066 Section X: Network Management
SHOW ACCESS-LIST
Syntax
show access-list
Parameters
None.
Mode
Privileged Exec mode
Description
Use this command to display the configurations of the ACLs on the switch.
An example of the information is shown in Figure 170. To display the port
assignments of the ACLs, refer to “SHOW INTERFACE ACCESS-
GROUP” on page 1067.
Figure 170. SHOW ACCESS-LIST Command
Examples
awplus# show access-list
UDP access-list 3001
permit any range 1 10 any range 1 10
IP access-list 3010
permit 149.11.125.0 mask 255.255.255.0 149.11.120.0 mask
255.255.255.0UDP access-list 3522
deny any range 12 100 149.123.159.0 mask 255.255.255.0 eq 2 vlan 7
UDP access-list 3602
deny any any range 67 87 vlan 2
UDP access-list 3670
deny any eq 10 any eq 10
UDP access-list 3672
deny any range 0 65535 any range 0 65535
IP access-list 3680
deny any 149.112.2.0 mask 255.255.255.0
IP access-list 3685
deny any any
IP access-list 3687
deny 149.11.124.0 mask 255.255.255.0 any
Total number of access-list = 8

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)