Allied Telesis AT-9000/28SP Command Line User's Guide

Chapter 55: 802.1x Port-based Network Access Control Commands
748 Section VIII: Port Security
AAA AUTHENTICATION DOT1X DEFAULT GROUP RADIUS
Syntax
aaa authentication dot1x default group radius
Parameters
None.
Mode
Global Configuration mode
Description
Use this command to activate 802.1x port-based network access control
on the switch. The default setting for this feature is disabled.
Note
You should activate and configure the RADIUS client software on
the switch before activating port-based access control. For
instructions, refer to Chapter 82, “RADIUS and TACACS+ Clients”
on page 1189 or Chapter 83, “RADIUS and TACACS+ Client
Commands” on page 1203.
Confirmation Command
“SHOW DOT1X” on page 781
Example
awplus> enable
awplus# configure terminal
awplus(config)# aaa authentication dot1x default group
radius

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)