Allied Telesis AT-9000/28SP Command Line User's Guide

Chapter 30: Syslog Client
414 Section IV: Event Messages
Deleting Syslog Server Definitions
To delete syslog server definitions from the switch, use the NO LOG
HOST command in the Global Configuration mode. The format of the
command is:
no log host ipaddress
To view the IP addresses of the syslog servers of the definitions, use the
SHOW LOG CONFIG command. You can delete just one definition at a
time with this command.
The switch stops sending event messages to a syslog server as soon as
you delete a definition.
This example deletes a syslog server definition for the server IP address
124.145.112.61:
awplus> enable
awplus# configure terminal
awplus(config)# no log host 124.145.112.61 3

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)