Allied Telesis AT-9000/28SP Command Line User's Guide

Chapter 60: sFlow Agent Commands
870 Section X: Network Management
SHOW SFLOW
Syntax
show sflow
Parameters
None.
Modes
Global Configuration mode
Note
Unlike most other SHOW commands, which are stored in the User
Exec and Privileged Exec modes, this SHOW command is located in
the Global Configuration mode.
Description
Use this command to display the settings of the sFlow agent on the
individual ports on the switch. The command displays information only on
those ports that have been configured for sFlow. Here is an example of
the information.
Figure 145. SHOW SFLOW Command
The fields are described in Table 81.
Port Sample-rate Polling-interval Collector-list
==== =========== ================ ==============
1.0.4 5000 120 149.44.12.15
1.0.5 5000 120 149.44.12.15
1.0.6 10000 200 149.44.12.15
Table 81. SHOW SFLOW Command
Parameter Description
Port The port number.

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)