Allied Telesis AT-9000/28SP Command Line User's Guide

Chapter 55: 802.1x Port-based Network Access Control Commands
758 Section VIII: Port Security
AUTH TIMEOUT SUPP-TIMEOUT
Syntax
auth timeout supp-timeout value
Parameters
supp-timeout Sets the switch-to-client retransmission time for EAP-
request frames. The range is 1 to 65,535 seconds. The
default value is 30 seconds.
Mode
Port Interface mode
Description
Use this command to set the retransmission time for EAP-request frames
from authenticator ports.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 777 or “SHOW DOT1X
INTERFACE” on page 782
Example
This example sets the retransmission time for EAP-request frames on
authenticator ports 3 and 4 to 120 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.3,port1.0.4
awplus(config-if)# auth timeout supp-timeout 120

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)