Allied Telesis AT-9000/28SP Command Line User's Guide

AT-9000 Switch Command Line User’s Guide
Section II: Basic Operations 317
Disabling IGMP Snooping
The command to disable IGMP snooping on the switch is the NO IP IGMP
SNOOPING command in the Global Configuration mode. To disable IGMP
snooping:
awplus> enable
awplus# configure terminal
awplus(config)# no ip igmp snooping
When IGMP snooping is disabled, the switch floods the multicast packets
on all the ports, except on ports that receive the packets.

Allied Telesis AT-9000/28SP Specifications

General

Number of Ports	28
Port Type	Gigabit Ethernet
Ports	24 x 10/100/1000Base-T, 4 x SFP
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Power over Ethernet (PoE)	No
Rack Mountable	Yes
Product Type	Switch
Layer	3
MAC Address Table Size	16K
VLANs	4K
Jumbo Frames	9K
Dimensions (W x D x H)	440 x 240 x 44 mm
Power Supply	AC 100-240V, 50/60Hz
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	10% to 90% (non-condensing)