Hardware Reference 43
C613-03092-00 REV J
• Diagnostic Messages: Check “Diagnostics Messages” to display
additional diagnostic messages in the AT-TFTP Server window when
debugging file transfers.
• IPv4 and IPv6: Choose whether AT-TFTP Server should respond to
TFTP requests received via IPv4 only, IPv6 only, or both IPv4 and IPv6.
• Firewall mode: select “RFC Compliant Mode” to allow multiple files to
be transferred simultaneously, or “Firewall Friendly” to force all TFTP
traffic to use port 69 as either the source or destination port. This will
only allow one file to be transferred at a time.
• Click the OK button when you finish.
3. To download a file from AT-TFTP Server:
On switches running the AlliedWare
®
operating system, at the command
line interface type the following command:
load method=tftp file=filename server=ipadd dest=flash
On switches running the AlliedWare Plus™ operating system, enter
Privileged Exec mode and enter the command:
awplus#copy tftp://ipadd/filename flash
filename is the name of the file to download and ipadd is the IP address of the
PC running AT-TFTP Server.
4. TFTP requests are logged to the AT-TFTP Server main window. To save a
TFTP Server log, select Save As from the File menu.
To Next Page
Loading...
Need help?
General
