Alltion (Guangxi) Instrument Co., Ltd.
Electromagnetic Compatibility | AC-5000 User’s Manual
Electromagnetic Compatibility
Without approval from Alltion (Guangxi) Instrument Co., Ltd., it may result in the electromagnetic
compatibility of the device or other equipment if it is not authorized to change or refit the device.
The design and test of AC-5000 colposcope comply with relevant operating instructions on
electromagnetic compatibility.
The equipment or system shall not be adjacent to or stacked together with other equipment. If it is
required, observe and verify whether it can operate correctly in such a configuration.
Requirements on Wire Installation
Non-shielded parallel wire
Key Components for Electromagnetic Compatibility
The electromagnetic compatibility key components of the product include the power adapter
and dimming circuit board, It will cause significant decreasingly in electromagnetic
compatibility transmission and immunity performance to use or replace with the accessories
with non-matched design,
Do not replace the components without authorization.
Guidance and Manufacturers Declaration–electromagnetic Emission
The AC-5000 colposcope is intended for use in the electromagnetic environment specified
below. The customer or the user of the AC-5000 colposcope should assure that it is used in
such an environment.
Electromagnetic Environment - Guidance
AC-5000 colposcope uses RF energy only for its
internal function. Therefore, its RF emissions are very
low and are not likely to cause any interference in
nearby electronic equipment.
AC-5000 colposcope is suitable for use in all establis
hments, including domestic establishments and those d
irectly connected to the public low-voltage power suppl
y network that supplies buildings used for domestic p
urposes.
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations
/flicker emissions
IEC 61000-3-3
To Next Page
Loading...