%5HY
Operation
Many of the screens used for Ethernet communications look and function the same and contain the same infor-
mation as the Alpha UPS Monitor screens. There are additional screens only available with Ethernet communica-
tions which are detailed below.
Configure Site Information
This screen is used to enter site location information into the UPS’s memory.
)LJXUH ² $OSKD8360RQLWRU&RQILJXUH6LWH,QIRUPDWLRQ
Communications
• Configure TCP/IP is used to set the UPS’s IP or TCP address.
• Configure SNMP is used to set the UPS for use with SNMP communications.
• Configure RS-232: You cannot change RS-232 parameters with this screen.
• Email Notification tells the card to send an e-mail message whenever selected UPS events happen.
)LJXUH ² $OSKD8360RQLWRU836&RPPXQLFDWLRQVVFUHHQ
To Next Page
Loading...
