DLM-600 installer & user manual Rev. 1.3 16-11-2011 15 / 39
SIA and Contact ID codes is present in the back of this manual or can be displayed in AlphaTool using
the Help function.
TELEPHONE NUMBERS
For each input, one or more telephone numbers can be programmed where the alarm and / or restore
message is reported to. Phone numbers are programmed in the tab "Dialer". The DLM-600 will always
begin calling the lowest (1, then 2, then 3, etc.) telephone number that is programmed for this input.
This makes it possible to create selective reporting for specific inputs and / or events.
ACCEPTATION
For each input you can program whether the alarm and / or restore messages should be accepted by
one or all telephone numbers.
To Next Page
Loading...