Information
In
Case
of
Difficulty
If you encounter a problem, please tum the power off, then
on
again. If
the unit
is
still not functioning normally, please review the items
in
the
following checklist. This guide will help you isolate the problem if the
unit
is
at
fault. Otherwise, make sure the rest
of
your system
is
properly
connected or consult your authorized Alpine dealer.
No function or display.
• Vehicle's ignition is off.
·
If
connected following instructions, the unit will not operate
with the vehicle's ignition off.
• Improper power lead (Red) and battery lead (Yellow)
connections.
· Check power lead and battery lead connections.
• Blown fuse.
• Check the fuse
of
the unit; replace with the proper value
if
necessary.
• Internal micro-computer malfunctioned due to interference noise
etc.
• Press the RESET switch with a ballpoint pen
or
other pointed
article.
Unable to receive stations.
• No antenna or open connection in cable.
· Make sure the antenna is properly connected; replace the
antenna
or
cable
if
necessary.
Unable to tune stations In the seek mode.
You
are in a weak signal area.
· Make sure the tuner is in the OX mode.
If
the area you are in is a primary signal area, the antenna may
not be grounded and connected properly.
· Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
The antenna may not be the proper length.
· Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Broadcast Is noisy.
• The antenna is not the proper length.
· Extend the antenna fully; replace it
if
it is broken.
• The antenna is poorly grounded.
- Make sure the antenna is grounded properly at its mounting
location.
CD Player/Changer not functioning.
• Out
of
operating temperature range +50°C
(+
120°F) for CD.
- Allow the vehicle's interior (or trunk) temperature to cool.
CD playback sound is wavering.
• Moisture condensation in the
CD
Module.
- Allow enough time for the condensation to evaporate (about I
hour).
40-EN
MP3, WMA
or
AAC Is not played back.
• Writing error occurred. The
MP3IWMNAAC
format is not
compatible.
- Make sure the
MP3IWMNAAC
has been written in a
supported format. Refer to "About
MP3IWMNAAC"
(pages 12-13). then rewrite in the format supported by this
device.
The sound Is not output from the speakers.
• Unit has no output signal
of
the internal amplifier.
- Power IC is switched to
"ON"
(page 20).
iPod does not play and no sound Is output.
• The iPod has not been recognized.
- Reset this unit and the iPod. Refer to "Initial System Start-Up"
(page 7).
To
reset the iPod, refer to the Owner's Manual
of
the
iPod.
Information
In
Case
of
Difficulty
If you encounter a problem, please tum the power off, then
on
again. If
the unit
is
still not functioning normally, please review the items
in
the
following checklist. This guide will help you isolate the problem if the
unit
is
at
fault. Otherwise, make sure the rest
of
your system
is
properly
connected or consult your authorized Alpine dealer.
No function or display.
• Vehicle's ignition is off.
·
If
connected following instructions, the unit will not operate
with the vehicle's ignition off.
• Improper power lead (Red) and battery lead (Yellow)
connections.
· Check power lead and battery lead connections.
• Blown fuse.
• Check the fuse
of
the unit; replace with the proper value
if
necessary.
• Internal micro-computer malfunctioned due to interference noise
etc.
• Press the RESET switch with a ballpoint pen
or
other pointed
article.
Unable to receive stations.
• No antenna or open connection in cable.
· Make sure the antenna is properly connected; replace the
antenna
or
cable
if
necessary.
Unable to tune stations In the seek mode.
You
are in a weak signal area.
· Make sure the tuner is in the OX mode.
If
the area you are in is a primary signal area, the antenna may
not be grounded and connected properly.
· Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
The antenna may not be the proper length.
· Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Broadcast Is noisy.
• The antenna is not the proper length.
· Extend the antenna fully; replace it
if
it is broken.
• The antenna is poorly grounded.
- Make sure the antenna is grounded properly at its mounting
location.
CD Player/Changer not functioning.
• Out
of
operating temperature range +50°C
(+
120°F) for CD.
- Allow the vehicle's interior (or trunk) temperature to cool.
CD playback sound is wavering.
• Moisture condensation in the
CD
Module.
- Allow enough time for the condensation to evaporate (about I
hour).
40-EN
MP3, WMA
or
AAC Is not played back.
• Writing error occurred. The
MP3IWMNAAC
format is not
compatible.
- Make sure the
MP3IWMNAAC
has been written in a
supported format. Refer to "About
MP3IWMNAAC"
(pages 12-13). then rewrite in the format supported by this
device.
The sound Is not output from the speakers.
• Unit has no output signal
of
the internal amplifier.
- Power IC is switched to
"ON"
(page 20).
iPod does not play and no sound Is output.
• The iPod has not been recognized.
- Reset this unit and the iPod. Refer to "Initial System Start-Up"
(page 7).
To
reset the iPod, refer to the Owner's Manual
of
the
iPod.
To Next Page
Loading...
