23
EDITING THE CHANNEL LIST
Go over the channels and press on the EDIT button and the select any of the DELETE, RELOCATE options and
mark the channel you want to process. Select once again when you want to delete it, and move the cursor to the
position you want, when you want relocate it. You can exit by responding YES to the RECORD CHANGES option
after you have completed your process.
CATV SETTINGS:
You change your DVB-C QAM settings from this menu.
POWER UNIT: You can use the power level as dBuV, dBm, dBuV.
CALLIBRATION: You can change your calibration level with these settings when you want to see your
measurement levels high or low.
MIN & MAX POWER: You can change your measurement strength level with the settings.
MAX BER: You can change your measurement BER maximal limit with the settings
FREQUENCY PLAN:
You can edit the appropriate frequencies in the region you are providing services in this menu. Thus will your
frequency plan be used with the settings you have made in all other menus and you will be able to perform faster
measurements. (Always control the correctness of the settings, since these setting are used in some menus.)
You can scan all channels and control the memory data for the CATV frequency plans and channel lists.
To Next Page
Loading...
Need help?
General
