1 | Introduction BYK-Gardner GmbH
8 spectro2guide Family 295 024 855 E 2405
1.5.2 FCC Declaration (USA)
This equipment contains a radio module with FCC ID QPU8000.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference when the equipment is operated in a commercial environ-
ment. This equipment generates, uses, and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harm-
ful interference in which case the user will be required to correct the interference at his own ex-
pense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause un-
desired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user´s authority to operate the equipment.
RF exposure statement (portable devices)
This device complies with the RF exposure SAR test exclusion requirements for portable devices,
if a minimum separation distance (2 cm) to the antenna is kept. If the device is used and held
correctly, the distance to the antenna will be maintained and the risk of human contact during
normal operation is minimized.
1.5.3 IC Declaration (Canada)
This equipment contains a radio module with IC ID 4523A-SN8000.
This Class A digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada’s license-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
1.5.4 Japanese Declaration
This equipment contains specified radio equipment that has been certified to the Technical Reg-
ulation Conformity Certification under the Japanese Radio Law.
MIC ID: R 006-000497
1.6 Intended Use
The instrument is designed to measure color, gloss, and fluorescence on different surfaces. Via
the integrated camera the current spot on the surface can be viewed on the display – allowing
exact positioning.
To Next Page
Loading...
