© Copyright 2014 Amano McGann, Inc. OPUS7000_Distributor_10062014 11
OPUS-7000 Distributor’s Manual
C
hange the state of the Paystation by pressing the button labeled with the
desired operational state. Press Return when finished. If the Paystation is
returned back to idle with a Closed operational status, the display shows the
message, “Closed please use the intercom button to contact the operator.” The
letter displayed in the bottom-right corner of the screen shows the current
troubleshooting code.
[Fig. 1.6A] The troubleshooting code is located in the bottom-right of the display
1.6.1 Troubleshooting Codes
A:
Forced out of service by operator
T: Trouble (i.e. reader dysfunctional, fee engine not properly set, etc.)
M: Coin note safe full
E: Out of change
I: Forced out of service by operation signal
F: Communication buffer full
S: Out of service by parameter or communication
2: Parameter required to initialize is not properly set
To Next Page
Loading...
