Amano OPUS-7000 Series - Import Parameters from a SD Card; Viewing Paystation Log Files; Viewing Function Counts

© Copyright 2014 Amano McGann, Inc. OPUS7000_Distributor_10062014 21
OPUS-7000 Distributor’s Manual
3.1.4 Import Parameters from a SD Card
A
list of parameters may be imported to the Paystation if a large number of
parameters are to be changed and a backup exists. Navigate to the
Common/Specific parameter menus and press Import CSV. A pop-up displays
verifying the CSV file is ready to be imported. Press Start to start the import or
Stop if there is a need to cancel.
T
he parameters are restored from the backup file located in
SD\DataBackup\SettingCSV.
I
MPORTANT: Some parameters such as device IP and machine
number need to be changed so they are unique. Failure to change
required unique values can result in loss of Paystation functionality.
3.2 Viewing Paystation Log Files
T
he OPUS-7000 series Paystation is capable of producing logs for many of its
functions. To view the Paystation logs, navigate to the Engineer Operation menu
and press Log File.
T
he available logs for the Paystation are:
E
rror: Error logs
Alarm: Logs of any switch alarms
Power Failure: Sudden unexpected shutdown of the Paystation
Operation: General operation logs
T Total: Pulled T-Total reports
Multi T Total: Pulled Multi T-Total Reports
Monitor: Configuration logs
Coin Safe Total: Pulled coin safe total reports
Note Safe Total: Pulled note safe total reports
Coin Hopper Total: Pulled coin hopper total reports
Note Dispenser Total: Pulled note dispenser total reports
Initialize All: Clear all logs
Operation Monitor: Paystation operation logs
3.3 Viewing Function Counts
T
he Function Count menu displays the number of times the Paystation has
performed a certain function. Navigate to the Function Count menu by entering
the Engineer Operation menu and pressing Function Count.
N
avigate through the function counts using the Previous and Next buttons. If it is
desired to change the current value of a count, press the gray button associated
with the function and use the keypad to enter the new value. Press E to accept
the change.