Amano OPUS-7000 Series - Set Parameters Back to Default

© Copyright 2014 Amano McGann, Inc. OPUS7000_Distributor_10062014 20
OPUS-7000 Distributor’s Manual
address of the parameter setting using the keypad and press E once the desired
parameter is entered. The Parameter menu will then display the parameter range
containing the submitted parameter number.
T
o change the value of the parameter, press the left most number (the parameter
number). The parameter number is highlighted blue to designate editing mode.
Enter the desired value using the keypad, and press E to confirm the change.
The value of the parameter is changed.
[Fig 3.1A] Adjust the parameter settings to the facility’s needs
P
lease refer to the appropriate parameter lists to configure the Paystation to the
facility’s needs.
3.1.3 Set Parameters Back to Default
T
o set the parameters back to default, navigate to the System Parameter menu
followed by Common Parameter or Specific Parameter (depending on which set
of parameters is to be returned back to default). Press the Default button once in
the Common/Specific menu.