Amano OPUS-7000 Series - Shutter Configuration; Manager Operation Menu

© Copyright 2014 Amano McGann, Inc. OPUS7000_Distributor_10062014 13
OPUS-7000 Distributor’s Manual
1.8 Shutter Configuration
T
he OPUS-7000 can be set to two sets of operation modes for the ticket shutter.
To make a change to the current mode, open the Paystation door and toggle the
Management Switch. Press Next to continue to page two of the First Time
Operation menu and select Shutter Control. The Shutter Control menu displays
the current state of the ticket shutter near the top of the display.
C
hange the current shutter mode by pressing Open or Automatic. An Open
state keeps the ticket shutter open. An Automatic state closes and opens the
shutter automatically based upon input from the arming and closing loops. Press
the desired state and select Return when finished.
1.9 Clearing Management Cards
A
Management card may be cleared of all information so it can no longer be
used at the Paystation. Ensure the Management card is present when performing
this operation. Open the Paystation door and toggle the Management Switch.
Press Next to continue to page two of the First Time Operation menu. Insert the
Management card and select Clear Password. Press Yes on the confirmation
pop-up to clear the information or No to cancel the operation.
MANAGER OPERATION MENU
T
he Manager Operation menu contains settings for both technicians and site
managers. Manager Operation is designed for the management of the OPUS-
7000 Paystation as it contains settings responsible for configuring money
management, reports, and password management.
T
o navigate to the Manager Operation menu, open the Paystation door and
toggle the Management Switch to load the First Time Operation menu. Press
Next to continue to page 2 of the First Time Operation menu and select To
Manager Operation. Enter the Management password (C1441104) and press E
to continue.
The
following sections will begin from the Manager Operation menu unless
specified otherwise.