Amazone EasySet 2 - Preparing the Easyset2; Switching the Easyset2 on and off; Enter Spread Rate

Preparing the EasySet2
EasySet 2
BAG0217.9 06.22
7
2 Preparing the EasySet2
2.1 Switching the EasySet2 on and off
Switch on the EasySet2.
→ The current software version is shown for 2
seconds.
→ The set mode is shown for one second.
→ The Work display appears.
Switch off the EasySet2.
→ STOP is shown for 2 seconds.
→ The total area efficiency is shown for 2 sec-
onds.
2.2 Enter spread rate
1. Select the spread rate setting.
→
The spread rate is shown in kg/ha.
2. , Enter the spread rate.
3. Save the value and go back to the
work display.