Mechanical adjustments
GreenDrill BAH0054-4 02.13
27
4.2 Scraper
An adjustable scraper is attached above the
sowing shaft.
The scraper can be adjusted using a lever (1) on
a scale of +4 to -5. Adjusting the lever allows
finer dosing of the seed spread rate.
Scale values -1 to -5:
The scraper is pressed against the sowing shaft
using the lever. The spread rate decreases
slightly.
Scale values +1 to +4:
The scraper is lifted off the sowing shaft using
the lever. The spread rate increases slightly.
For free-flowing fine seeds, set the lever slightly to a minus position
on the scale.
For large seeds, set the lever slightly to a plus position on the scale.
The sowing table values were determined in the basic position
(scraper position 0).
To Next Page
Loading...