Amazone GreenDrill 200-E - Turning at End of the Field; When the Work Is Completed; Emptying the Hopper

GreenDrill 3.2 on-board computer
GreenDrill BAH0054-4 02.13
37
6.8 Turning at end of the field
1. Press and hold the button until the green LED goes out
the sowing shaft stops
the blower fan continues to run.
2. Lift the base machine and turn.
3. After turning the machine, press the
button
the sowing shaft rotates, sowing begins.
6.9 When the work is completed
1. Press the button
Switch off the sowing shaft
2. Press the
button
Switch off the blower fan
3. Press the
button
the machine is switched off.
4. Pull the power plug out of the on-board computer.
When the work is completed, first switch off the sowing shaft, then the
blower fan and finally the on-board computer.
Pull the power plug out of the on-board computer if the machine is not
being used.
6.10 Emptying the hopper
1. Prepare the machine for emptying the hopper (see above)
2. Press the
button, hold it and press the button
The sowing shaft rotates at maximum speed
The blower fan motor remains switched off.
3. Press the
button as soon as the hopper is empty and the seed wheels no longer convey
seed.
The sowing shaft motor is switched off.
The sowing shaft can be stopped at any time by pressing one of the
following buttons
.