GreenDrill 5.2 on-board computer
GreenDrill BAH0054-4 02.13
57
7.7.3.3 Radar sensor and working position sensor connections
Requirement:
The tractor does not have a 7-pin tractor signal socket.
The following are subsequently mounted
the radar sensor (for the travel speed)
the working position sensor
The splitter (A) connects
the on-board computer (12-pin)
to the radar sensor
to the working position sensor
Interface (1): on-board computer
Interface (2): radar sensor
Interface (3): working position sensor.
Interface (2) transmits the travel speed signals (km/h).
Interface (2) transmits the "Position of the work sensors" signal [e.g.
lifting gear signal])
To Next Page
Loading...