GreenDrill 5.2 on-board computer
GreenDrill BAH0054-4 02.13
47
7.5.3 Area calculation
Area calculation
is carried out using the values from the calibration test
begins as soon as the sowing shaft starts to rotate
is carried out using the "actual" travel speed values
(when 7-pin signal plug is connected).
The following are displayed:
the total area [ha]
the part area [ha]
Pressing the
button for 5 seconds sets the part area to zero.
The total area cannot be reset.
When operating without a speed sensor, the actual tractor speed
must correspond with the set value.
Otherwise, the actual worked area will differ from the displayed area.
To Next Page
Loading...