GreenDrill 5.2 on-board computer
46
GreenDrill BAH0054-4 02.13
10. Weigh the calibrated seed and enter the value [kg] in the on-
board computer.
The required sowing shaft speed is calculated automatically.
If this changes the sowing shaft speed by more than
3%
the adjacent display appears
the calibration test has to be repeated.
Display at the end of the correct calibration test
The display returns to the main menu after a few seconds, and
one of the two displays listed below appears.
Display of the spread rate [kg/ha]
in the main menu without connected speed sensor.
Display of the spread rate [kg/ha]
in the main menu with connected speed sensor.
To Next Page
Loading...